Hornby Class 08 TTS Sound Decoder -

Discontinued

Product Code: R7146

 

Production Details:

Hornby TTS Sound Decoder - Class 08. This DCC sound decoder requires a dcc controller to operate both the movement and sound, of the locomotive it is fitted to.

Function list:

F0 Headlight
F1 Engine Start
F2 Whistle Long
F3 White 2 Burts
F4 Brake Squeal
F5 NOTCH UP
F6 NOTCH down
F7 Return to IDLE
F8 Thrash
F9 Cold start override
F10 Horn 3 Burts
F11 Horn 2 Bursts
F12 Reverser
F13 Air Release
F14 Air Dump
F15 Detonator
F16 Couple
F17 Un-Couple
F18 Primer
F19 Exhauster
F20 Compressor
F21 Handbrake
F22 Spirax Valve
F23 Flange Squeal
F24 Metal Door
F25 Aux (if used in locomotive)

Instruction Guide:

Hornby TTS decoder installation guide Installation guide

 

Features:

- Supports short and long decoder addresses
- Adjustable acceleration and deceleration
- Back EMF load compensation
- Up to 19 controllable spot sounds dependent on model including whistles or horns etc
- Two sound channels allowing for simultaneous play of full locomotive engine sounds, & individual spot sounds e.g. horns, whistles, brakes, wagons coupling etc. NOTE: Only one spot sound can be played at the same time
- It is possible to alter the volume of each sound through an individual dedicated CV. Range 0-8
- Decoder is equipped to support directional front and rear lighting operation via F0 on the controller, providing that the product is fitted with lights
- The decoder is equipped with 1 aux function output controlled by F18 or F25 dependent on locomotive type (diesel or steam)
- Motor current - maximum continuous 500mA
- Motor current - peak 1amp (no function load)
- Function output current maximum—100mA (unprotected)
- Decoder current maximum continuous - 800mA (shared motor and functions)
- Number of sound channels - 2
- Termination - 8 pin plug NEM652. NMRA

  

IMPORTANT - The decoder does not support sound under DC (analogue) operation. Sounds can only be played under DCC (digital) operation. This applies to all sounds, both running and spot sounds. The locomotive's motor may be controlled under DC operation.

Discontinued